Other Network Architecture Subjects

I want to connect a specific SENSOR(IP DEVICE) to my network wirelessly!{ The application is as simple as connecting a  Trednet wireless adapter to the TV to access the HOME WIRELESS NETWORK to WATCH NETFLIX on INTERNET TV!But my Client wants to use ...

Does anyone have experience, and is willing to share, on setting up access points where the connected users are authenticated through 802.1x? Here is my setup. Cisco 1240AG and 1131AG connected to an 802.1x enabled switch. The switch gets puts users ...

Dear Sir, I have a question about memory usage. When I use command "show ver", it shows Cisco 2821 (revision 53.51) with 223232K/38912K bytes of memory. When I use command "show process memory", it shows Processor Pool Total:  112570512 Used:  385533...

Hi,I have been trying to add devices to RME with no luck. I am running into DDTS CSCin56596 which says to reinitialize the database. Well I did once andn then I tried to import from a csv file and the device import failed again. So this time I was...

Hi fraindsI have cisco 1841 router1841 Software (C1841-ADVSECURITYK9-M), Version 12.4(3g)ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)with2 FastEthernet interfaces2 Serial(sync/async) interfaces1 Virtual Private Network (VPN) Mod...

Hello,I'm running RME an Performance monitor as part of the Ciscoworks Common Services that is installed as part of Cisco Security Manager.  I installed CW Common Services and CSM first and added all the licenses needed.  After that I installed RME a...

Hi people,I work on a network with about 1000 switches/routers of which a hundred of 2950 switches (2950G, 2950ST and so on...).We monitor the network with some management tools such as Groundwork, Netcool and CiscoWorks LMS (via ICMP). Randomly for ...

We have 3500Xl series switches and some are running port monitoring so we can gather data on what kind of traffic is flowing through our network. The question is if 1 ethernet port is monitoring all the other ethernet ports on it, what kind of perfor...

Hi all,On my network i am trying to give preference to certain traffic type A over another traffice type B  over a VSAT link.the VSAT link is about 64Kbps/64Kbps and this link is connected to a router subinterface.I initially thought of CBWFQ to rese...

Hey guys, I've been sifting through cisco doc's online and still can't find a solution to my problem.. perhaps I'm missing something..I have a Cisco2821 router and its not detecting a NME-16ES-1G-P card..Cisco IOS Software, 2800 Software (), Version ...

Is it possible to run Multilink PPP on 2 T1s while also doing transparent bridging?If so, Do I need to put bridge-group 1 on my multilink interface?thx

Hi, all! I have 2 Cisco 2821 routers with the same configuration. IOS c2800nm-spservicesk9-mz.124-25b.bin.When i try to get ifInOctets|ifOutOctets on subinterfaces via snmpwalk, an the one router is all OK, but other returns me zero.For example:IF-MI...