Other Network Architecture Subjects

If im running eigrp on my router between my 2 networks, but have a default route pointing to another network, will it use the default route for everything, or will it still use eigrp for the advertised networks as its more specific, also we have a de...

Whats the command to enable tacacs on initial login instead of having it go to the menu . We already have it for enable mode . Used to know this and there seems to be very limited info on CCO on this old switch. I believe it was just a single c...

I have an issue where switchports configured for port security and mac-address sticky are going err-disabled for no apparent reason. They are not being replaced. They have not been moved. They were working fine for weeks. I can tell you that it start...

I'd like to redistribute a pile of statics on a router into OSPF. However I don't want to redistribute ones that go via a particular router.Would an extended access list with the particular router as the destination do this ?Router ospf 1redistribut...

Hello, I'm new on 7200 Series, I have one in my lab in the following configuration:7206 VXRI/O ControlerPA-FENPE40020MB flash card externI would like to ask, what is about with this flash card, there is Router#sh flash-#- ED ----type---- --crc--- -se...

Hello I need some clarification about routing. If I had these interface address: 10.1.1.1 255.255.128.0 192.168.1.1 255.255.255.24055.22.1.1 255.252.0.0when configuring routing what would I enter for the network eg. #router ripv2,ospf,eigrpnetwork " ...

is it possible to have 2 default routes on my router, but only use one of them for http traffic ?

Would like to get some information on network performace audit & architecture audit. I need some help on review of existing architecture, finding current choke points and proposing better network. It can be also from the bandwidth perspective. It ...

I have a mental block and need help. I have 6 3750 switches on a stack. However, I only have .5 meter cables and because of cable management, I can't connect switch 6 back to switch 1 because of the short stackwise cable. As usual, I am out in the m...

I am a bit confused with the process. Following a scenario from Halabi, I setup OSPF and BGP in a similar situation. I have two border routers both receiving a default route via bgp from different providers. I have these two border routers running iB...

Hi, another company is putting a vpn device into our dmz, it has having an external address on it, the external addresses are all routed to our pix firewall, my question is can we put this vpn device on an external address sitting off the back of the...

am i right in saying rip 1 v1 you cant use vlsm ? but with rip 2 you can ? does this mean that when you add networks into rip v2 you put in a subnet mask after the network statement ?

Hi!I have a network with only 2 2924 connected together so I get 48 ports. The problem: The network was getting slow and it stopped for a while, then it was OK for a while. Up and down. Then I replaced the 2 2924's with a simple 3com and then it was...

when I add an eigrp network, do I use the subnet mask, i.e 172.19.0.0 0.0.255.255 ?

hi all, on my site we have a router with 4 remote sites attatched, it has dialler interfaces. would this work if all sites were on a different subnet as im sure I have seen setups this way ?