How do I search through Interface descriptions or Interface-Profile descriptions or Interface-Profile Names in ACI? The only way I can find anything is using the Endpoint tracker but that assumes I already know the IP address.
Hi all i can't delete a vlan. I access in global configuration mode I launch no vlan 2 but when I run show vlan I see vlan 2 down but it is not deleted. I then tried to access the database and the message appears: "" "% Warning: It is advisable to co...
Hi all I found a very strange setup of one of our partner in the network, wondering what this community think about it. About the security of the fact to have Internet and private networks on the same link. Here are the details: - There is an edge ro...
Hi all,I had been allotted a private IP address in the range 10.53.1.* by my organisation, which uses Cisco 1941 router. later, I was asked to change my IP address to 10.255.53.* series and so did I. But some PCs in the same local network as mine are...
Hello can someone tell me how do i make it so that a user can have access ,in one especific interface only, to modify that ip address and the description but NOT be able to do the shutdown command, and on the other interfaces ,the same user, only hav...
Hello everyone, I try to transfer an Image on my Gateway router via tftpd32. but I got the "timed out error". I tried to transfer a smaller text, again got the same error. Does anybody know what could be the issue ? Best regardsAna
Hello Guys, Hopefully, you can provide me some guidance, I'm trying to set up a Site to Site VPN between Azure (I) and Cisco ASA (Customer), on the Azure side I created it as Route based and sent the script to the customer, however, I'm not able to g...
Hi All, I am hoping someone can help with this issue.I have configured a cisco 9300 24T-A to disable password recovery and under a particular use case I need to ignore startup config. When both of these are enabled, my switch continuously crashes dur...
I'am try to flash AP to Autonomus from tftp. FW is off AV is off. Communication betwen AP and Computer is enable. When i try to flash boot mode via tftp:examining image...%Error opening tftp://255.255.255.255/ap3g1-k9w7-tar.default (connection timed ...
Hi all. I'm working in a private-sector bank in India. I have this question in my mind that how a bank's network connects the hosts to its data centre via MPLS or any other means. The 'branches' of the bank are having their own cisco routers at their...
Is it possible to configure multiple ports in a Catalyst switch running IOS 12.0 the way you can with CatOS? I used to be able issue a command like set port duplex 9/1-48 full and not have to configure each individual port.I haven't been able to find...
Hi all,We have a project to redesign our core switches, this is my first time setting up vpc on 2 n9k 9372tx and wanted to get some pointers on which is a good direction, I've searched around, I know everyone has a different setup on their networks s...
Hello you network guru's out there. I'm looking for help with a very strange issue which is happening in my home network.It is most likely NOT CISCO related, but you are network specialists, you can point me the right direction at least.Intro:I have ...
I read this document and have confused for this part as follows"SD-WAN TechnologiesThe Meraki SD-WAN implementation is comprised of several key features, built atop our AutoVPN technology.Dynamic Path SelectionDynamic path selection allows a network ...
