Can anyone tell me why I couldnt see another network of 10.99/16 from my 10.8 network, I had to put routes on the pc's to get tho the router for this, does it just presume that cause its on a 10 network its on the local lan even though its looking ...
Hi ,We will be connection two core Layer switches 4948's into two 3662 routers. It has been requested to run EIGRP between the four devices , and putting all four in the same subnet on VLAN901. Will this load balance properly over the uplinks, as we ...
Hi allJust a quickie, on my cisco router, whats the difference between using the dhcp client, or server mode, my router is giving out dhcp addresses via its lan interface and its setup as client , i would of thought it would be server cause its givin...
Is it possible for me to replace my vpn client on my pc with some sort of configuration on my router that initiates the tunnel rather than loading the vpn client on my pc ?
See the attachment pleaseRequirements:1.Using only physical interfaces configure a Frame Relay hub-and-spoke network between RTA and RTB and RTC, RTB as the hub.2.Traffic from RTA destined for RTC should transit RTB, and vice versa.3.Use only the DLC...
Hello,I am trying to setup a dot1q-tunnel on a Catalyst 6506 running IOS 12.2 and am running into trouble. I have followed everything in the manual and from other's examples, but I continually get the error:Command rejected: Gi1/1 doesn't support 802...
I have two 2800 series routers on the same LAN configured with HSRP.I have configured the primary router as dhcp server :ip dhcp pool pool1 network 10.10.10.1 255.255.255.192 dns-server 212.89.10.45 domain-name study.co.dr default-router 10.1...
Hi,we frequently see this syslogmessage at our Catalyst 4000/4500 switches:%C4K_L2MAN-6-INVALIDSOURCEADDRESSPACKET Packet received with invalid source MAC address (45:00:05:DC:E1:05)I do understand the meaning of the message but I don't understand w...
Hi, we have 12 cisco 2950T's stacked/trunked in a daisy chain fashion. I was told that this was not very efficient.Would purchasing a 2960G and cascading the switches to it be better ?thx jason
I was configured IPX routing with IPX EIGRP routing protocol.I encounter a problem which the IPX users login to the novell server and left the application open for a few hours.After a few hours the IPX user PC prompt that the connection loss to the s...
In a bit of a crisis...This connection is a Satellite shot and I have a Protocol Down...Would the high amount of CRC errors be related to a sandstorm that is going on right now? Talking to the signal guys and they say it's "clear"... Any point in th...
