Can I use one of the E1 of a NM-2CE1U with one AIM-ATM module to provide AT

[Alejandro Cadarso Cerdeirina]

I have a 2620 with a NM-2CE1U (2-Port Channelized E1/ISDN-PRI Unbalanced Network Module), actually I'm using only one of the E1.

If I install a AIM-ATM module, could I use the free E1 controller in the NM-2CE1U for ATM processing, or the AIM for ATM WAN Access is only supported for VWIC-MFT cards?

Regards

Alejandro

[tepatel]

I think you want to use Data over E1 ATM network using AIM-ATM module right?

you need to use VWIC cards..Here is the url for more on "how to use AIM-ATM" for different applications.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xb/122xb_2/ft_gins2.htm

Locate table 1.