cisco Switch 9300 Series HSRP

[sroodit81]

HI guys

i buy a new switch from Cisco with the model and firmware Version

C9300L-48T-4G

SW Version: 16.12.4

SW Image: CAT9K_IOSXE

i try to used standby ip for Enable HSRP but the command it no exists!

I read for the document about this model of the switch should be supported by this version

please can you anyone advise me if any kinds of configuring steps needed to enable the HSRP

[marce1000]

 - Post exact configuration=sequence tried , including the resulting error(s) , also check this document for guidelines :

        https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-11/configuration_guide/ip/b_1611_ip_9300_cg/configuring_hsrp.html

 M.

[sroodit81]

hi dear
the problem the command it does not exist to run

[balaji.bandi · Accepted solution]

You need Network Advantage license for HSRP

check what License you have.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst9300/software/release/16-9/release_notes/ol-16-9-9300.html

[sroodit81]

many thanks to answering me

hi can i check on the switch

[sroodit81]

i checked i have : 9300L Cisco DNA Essentials , 48 port license

and how can i upgrade the license

[balaji.bandi]

Contact License team ( or sales rep or partner) - Now everything now is smart License.

[paul driver]

Hello

show version 

[sixvilane6]

Hi All, was stuck with a similar scenario customer ordered kit with essential licence, was able to active athe Network Advantage via CLI, apply command below, then save config and then reload

switch(config)#license boot level network-advantage

write

reload

[Trapnasti]

Use "hsrp" instead of "standby". The rest of the configs should be the same.