cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
199
Views
5
Helpful
1
Replies

Duplicate frame relay maps.

jasonbegley
Level 1
Level 1

I have router A with 2 serial frame relays, dlci 101 and 102. I have remote router B with 1 serial frame relay dlci 150. I was planning on moving router B from frame leg #2 dlci 102 to frame leg #1 on dlci 101. Everything is already configured on telco side. I see dlci 101 and 102 on router B and I see dlci 150 on both frame legs on router A. Can I just add frame maps on both routers for both dlci's and then change routes, or would the redundant paths cause problems?

1 Reply 1

n2-goes
Level 1
Level 1

Hello,

If the pvc between 102 and 150 is already created, you should be able to add the frame-relay map to your router. By adding the new map, you effectively have 2 path between Rtr A and Rtr B.

Do not forget, you are paying for both until you cancel the old pvc.

HTH,

Nadine.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: