12-03-2015 10:15 AM - edited 03-03-2019 08:04 AM
I have a known good fan module that does not work when plugged into a 15454 Cerent chassis. Any ideas on where to check first? Pin-out of the connector on the back of the shelf possibly?
12-04-2015 02:54 PM
refer to the initial troubleshooting guide below:
http://www.cisco.com/c/en/us/td/docs/optical/spares/15454/sonet/guides/454fan.html
http://www.cisco.com/c/en/us/support/optical-networking/ons-15454-series-multiservice-provisioning-platforms/products-troubleshooting-guides-list.html
http://www.cisco.com/c/en/us/td/docs/optical/15000r9_1/15454/sdh/troubleshooting/guide/454e91ts.pdf
its already eos, so the rma would not be possible from tac. but you check it once for clarity.
regards,
-Do rate if it helps.
03-15-2016 11:23 AM
Thank you. I found a spare daughter board that is wired to the fan module connector, and replacing it fixed the trouble.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: