cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
190
Views
0
Helpful
1
Replies

Help with config for 2620 routers with VWIC-2MFT-G703 for E1

p-tully
Beginner
Beginner

Currently have 3 x 2620 routers each fitted with 1x VWIC-2MFT-G703 interface cards. E1 G.703 channels are 75ohm unbalanced, unframed, linecode is HDB3, clocksource is line. The E1 controller shows no alarms and CD is lighting up OK. However cannot ping between routers or communicate between routers either back-to-back or over E1 channel. Should the E1 controllers be 'mapped' to an interface, given an IP address or similar?

Any suggestions or samples of working IOS coding for similar E1 connections would be greatly appreciated.

1 Reply 1

anderson-david
Participant
Participant
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers