Need help configuring a 1-Port RJ-48 Multiflex Trunk -E1 for data only

[dagates]

I am having a third part stage a 1-Port RJ-48 Multiflex Trunk for a E1 Frame Relay access circuit. To make is even a little harder the client is installing the router. I do not have any experiance with the 1-Port RJ-48 Multiflex Trunk card and am looking for somebody with experiance for assistance.

Can somebody either provide me a sample configuration for a 1-Port RJ-48 Multiflex Trunk - E1 with data only (No voice is involved) or guide me to usefull info on how to configure this module?

I'm finding quite a bit of info but it is quite lengthy and all involves voice.

[lgijssel]

Just this week I have configured a similar module in a 1721 router to connect to an Internet provider. They were using Framed G703. Config like this:

controller E1 0

channel-group 1 timeslots 1-31

This auto-creates interface s0:1 on which all subsequent configuration can be done.

int s0:1

bandw 1920

ip addr ..

I assume that you should configure the interface with your standard Frame Relay config.

Please ask if you require a setup for unframed G703.

Good Luck!

Regards,

Leo