cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
777
Views
10
Helpful
1
Replies

Ongoing TFTP requests from several Cat 3500XL switches

Mel Popple
Level 1
Level 1

I'm experiencing repeated tftp requests for config files from several of the Cat 3500XL switches on the network. These are clustered with standby cluster

commanders activated.

All switches are running IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5)WC3b.

The following is the the output from the TFTP server that is running on my laptop:

Connection recieved from ***.**.121.251 on port 1765

Read request for file <network-confg>. Mode octet

Error : EACCESS. CreateFile returns 2: <The system cannot find the file specified.>

That is repeated for a couple of times and then the following:

Connection recieved from ***.**.121.251 on port 3179

Read request for file <cisconet.cfg>. Mode octet

Error : EACCESS. CreateFile returns 2: <The system cannot find the file specified.>

And finally changes to this:

Connection recieved from ***.**.121.251 on port 4430

Read request for file <group48-d1-confg>. Mode octet

Error : EACCESS. CreateFile returns 2: <The system cannot find the file specified.>

Non of the switches have anything in their start configs that tell them to look to a tftp server for any of their configs. Any ideas

Regards

Mel

Here is the Show Version output:

GROUP48-D1#sh ver

Cisco Internetwork Operating System Software

IOS (tm) C3500XL Software (C3500XL-C3H2S-M), Version 12.0(5)WC3b, RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2002 by cisco Systems, Inc.

Compiled Fri 15-Feb-02 10:51 by antonino

Image text-base: 0x00003000, data-base: 0x00337600

ROM: Bootstrap program is C3500XL boot loader

GROUP48-D1 uptime is 19 hours, 15 minutes

System returned to ROM by power-on

System image file is "flash:c3500XL-c3h2s-mz.120-5.WC3b.bin"

cisco WS-C3548-XL (PowerPC403) processor (revision 0x01) with 16384K/1024K bytes of memory.

Processor board ID FAA0436I0E3, with hardware revision 0x00

Last reset from power-on

Processor is running Enterprise Edition Software

Cluster command switch capable

Cluster member switch capable

48 FastEthernet/IEEE 802.3 interface(s)

2 Gigabit Ethernet/IEEE 802.3 interface(s)

32K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address: 00:03:6B:97:4A:80

Motherboard assembly number: 73-3903-04

Motherboard serial number: *************

Power supply serial number: NONE

Model revision number: A0

Motherboard revision number: B0

Model number: WS-C3548-XL-EN

System serial number: **************

Configuration register is 0xF

1 Accepted Solution

Accepted Solutions

wkumari
Level 1
Level 1

Try doing:

conf t

no service config

end

I sounds like you have service config on (it is the default in some versions) and the switches are trying to TFTP their configs....

View solution in original post

1 Reply 1

wkumari
Level 1
Level 1

Try doing:

conf t

no service config

end

I sounds like you have service config on (it is the default in some versions) and the switches are trying to TFTP their configs....

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: