10-14-2005 03:23 AM - edited 03-03-2019 12:25 AM
Hi,
I have a set of 3750 switches which are stacked into 2 sets of 3. I have creted a port channel on each stack that connects to the other stack, as it is cross stack I have used channel-mode on. when i type the follwoing command, some values show as zero, is this a bug, or just not supported?
show interface po1 ether
Age of the Port-channel = 18d:03h:58min:11s
Logical slot/port = 10/1 Number of Ports = 3
GC = 0x00000000 HotStandBy port = null
Port state = Port-channel Ag-Inuse
Protocol = -
Ports in the Port-channel:
Index Load Port EC State No of bits
------+------+------+-------------------+---------
0 00 Gi1/0/28 On/FEC 0
0 00 Gi2/0/28 On/FEC 0
0 00 Gi3/0/28 On/FEC 0
Shouldnt I see the Load entries and bits entries change from 0?
10-20-2005 06:10 AM
check the following case for a similiar issue :
http://www-tac-rtp.cisco.com/Teams/ks/casekwery/casekwery.php?Case=D525212&tz=-330
10-22-2005 03:27 AM
Beth-martin,
the link doesnt seem to work is thee=re case number you can advise so I can review thsi further?
many thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide