Hi everyone,
I'm having the following problem:
I have two Fabrics, with 2 Cisco MDS SAN Switches each, just call them mds1_fabric1, mds2_fabric1 and the same for fabric2.
I create a zone in mds1_fabric1, then copy run start. After this, some zones I had defined in mds2_fabric2 disappears. If I recreate disappeared zones in mds2_fabric1, original zone created in mds1_fabric1 disappears after copy run start! This is going me crazy.
There's only one Zoneset and one vsan.
mds1_fabric1# show fabric switch information vsan 1
VSAN 1:
--------------------------------------------------------------------------------
Switch Name Model Version Sup Memory
--------------------------------------------------------------------------------
mds1_fabric1 DS-C9148-16P-K9 6.2(23) 1 GB
mds2_fabric1 DS-C9148-16P-K9 6.2(23) 1 GB
mds1_fabric1#
I would very appreciate any help, any hint, any suggestion.
Regards!