cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
687
Views
0
Helpful
2
Replies

show run caused High CPU Utilization..

mmendis
Beginner
Beginner

Hi all,

I have Cisco 2851 router which is normally have 50% of CPU usage. When I tried to enter show running-configuration router get disconnected for about 3 -4 second and latency increased for above 300ms, this will go for about 1min before showing show command result. Can any one give me clue what causing this issue ??

System image file is "flash:c2800nm-advipservicesk9-mz.124-24.T.bin"

1 ACCEPTED SOLUTION

Accepted Solutions

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

That's an old IOS.

Go to the Cisco Bug Toolkit and I'm sure your symptom has already been identified.

View solution in original post

2 REPLIES 2

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

That's an old IOS.

Go to the Cisco Bug Toolkit and I'm sure your symptom has already been identified.

Thanks Leo

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: