Hi folks,
Have a look at the config of this remote router on test network I've constructed:
controller E1 0/0
channel-group 0 timeslots 1-31
!
controller E1 0/1
!
!
interface FastEthernet0/0
no ip address
duplex auto
speed auto
!
interface FastEthernet0/0.1
encapsulation isl 1
ip address 10.10.211.100 255.255.255.0
no ip redirects
!
interface FastEthernet0/0.2
encapsulation isl 2
ip address 10.100.66.2 255.255.255.192
no ip redirects
ip policy route-map wlan1
!
interface FastEthernet0/0.3
encapsulation isl 3
ip address 10.10.213.100 255.255.255.0
no ip redirects
ip policy route-map wlan2
!
interface FastEthernet0/0.4
encapsulation isl 4
ip address 10.10.214.100 255.255.255.0
no ip redirects
!
interface FastEthernet0/0.5
encapsulation isl 5
ip address 10.10.215.100 255.255.255.0
no ip redirects
!
interface Serial0/0:0
no ip address
encapsulation frame-relay
no keepalive
!
interface Serial0/0:0.1 point-to-point
ip address 10.210.111.2 255.255.255.252
frame-relay interface-dlci 101
!
interface Serial0/0:0.2 point-to-point
ip address 10.210.112.2 255.255.255.252
frame-relay interface-dlci 102
!
interface Serial0/0:0.3 point-to-point
ip address 10.210.113.2 255.255.255.252
frame-relay interface-dlci 103
!
interface Serial0/0:0.4 point-to-point
ip address 10.210.114.2 255.255.255.252
frame-relay interface-dlci 104
!
interface Serial0/0:0.5 point-to-point
ip address 10.210.115.2 255.255.255.252
frame-relay interface-dlci 105
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
ip classless
ip route 10.210.211.0 255.255.255.0 10.210.111.1
ip route 10.210.214.0 255.255.255.0 10.210.114.1
ip route 10.210.215.0 255.255.255.0 10.210.115.1
ip route 192.168.0.0 255.255.255.0 10.210.112.1
ip route 192.168.123.0 255.255.255.0 10.210.113.1
ip http server
!
access-list 1 permit any
route-map wlan1 permit 10
match ip address 1
set ip default next-hop 10.100.66.1
!
route-map wlan2 permit 10
match ip address 1
set interface FastEthernet0/0.3
set ip default next-hop 10.10.213.103
!
end
fa0/0.1 is an isl trunk to fa0/1 on a cisco 2924 switch. In vlan 2 (fa0/2) I have an ADSL router (cisco 837) connected. Everything works fine except I can't ping the ADSL router (cisco 837) from s0/0:0.2 (10.210.112.2) although I can ping 10.100.66.2 from s0/0:0.2. Why is this? Any ideas? I've conducted tests without policy based routing configured but still the same result.
