cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
116
Views
0
Helpful
3
Replies

Why doesn't the TV in my packet tracer display anything?

XXXCEO
Beginner
Beginner

Hello, 

In my packet tracer, after connecting the coaxial cable splitter (coaxial2)  to the TV using the TV cable, once I turn on the TV, there's a green arrow signal and when I turn it off, it shows a red arrow signal. 

 

According to Packet tracer, if my connection is right, the TV is supposed to show an image. So why is it showing green signal for ON and red signal for OFF, could it be owing to the version of the packet tracer I'm using? I'm using Cisco Packet Tracer 8.1.1

3 Replies 3

Martin L
VIP Advisor VIP Advisor
VIP Advisor

You must manually add an image now; your Image goes into Cloud under Config tab , Global settings, then TV settings, just below Name of Cloud

You can attach your PT file here but it must be in a zip format

 

Regards, ML
**Please Rate All Helpful Responses **

Hello,

 

I have added the TV to cloud but it doesn't display on the virtual tv on the workspace, only display on the TV physical properties gui box

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers