09-30-2009 01:05 AM - edited 03-01-2019 02:14 PM
Hi,
I have a 7609 with a WS-X6748-GE-TX. When I show the port capabilities I
can see rx-(1q8t), tx-(1p3q8t)
If I show queueing on an interface I see all the WRED and WRR queue
configuration.
This is great, I can make changes and view changes.
I also have an ES20 and ES20+ line card in the chassis. When I show the
port capabilities I see x-(NotDef-t), tx-(NotDef-t)
When I show queueing on an interface I see nothing for the ES20. For the
ES20+ I get
Interface GigabitEthernet1/1 queueing strategy: Weighted Round-Robin
Port QoS is enabled
Port is untrusted
Extend trust state: not trusted [COS = 0]
Default COS is 0
So the ES20 tells me nothing and the ES20+ only shows a subset of what I
see with the WS-X6748-GE-TX.
Is there something I am missing in my config to show what queues I have
available on the ES line cards '(1p3q8t)'
From reading the line card configuration guides I can see ingress
scheduling is not supported and egress is but when I configure a egress
policy-map with my random-detect configuration I still see no queueing
info for the ports.
Thanks
Anthony
09-30-2009 05:53 PM
Hi Anthony,
ES and 6748 are two completely different type of LC based on different hardware.
ES20 LC support 16K hw queues to give you an example in addition to H-QoS, shaping,..
You should use the show policy-map interface command instead.
HTH
Laurent.
10-01-2009 03:29 AM
Hi Laurent,
Thanks for the info.
Regards
Anthony
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide