Other Topics - Small Business

Hi, I have an ATA 192, but the client is asking if it is possible to configure the "Shared Line" feature on this device. The datasheet does not mention it, so I need to know if it is possible, and if so, could I get a document confirming this?

Hi guys. I have a question regarding the Small Business license for FPR1010. According to the attached documentation, when purchasing the FPR1010T-SBE-L license, the customer is entitled to device management via CDO. To our surprise, apparently, to m...

Hello,I'm trying to connect to MMB on Cisco C880 M4 chassi via com port and been following the manual instructions. I want to start configuring the chassi initially to later instead use the web gui. I'm unable to get anywhere as I get no response in ...

craigaredpath Community Member‎07-28-2024 03:01 PM I'm supporting a site with new Cisco CBS switches - Replacing a lot of old 2960's for the business switches. I use netmiko to gather port information from the switches and then display it on a web pa...

Cisco ASA question2 Questions:1-why cant i see interface eth1/2 and 1/3 in output?2-Also, how to find out which ports are part of port-channel?fw# show int ip briefInterface IP-Address OK? Method Status ProtocolInternal-Data0/0 unassigned YES unset u...

Hii Please I need to know how to go about renewing smartnet license for a Cisco device, both as a customer and as a partner. Thank you.

Cisco Catalyst 9300L - Network Essentials - switch - 48 ports - rack-mountableCISCOC9300L-48P-4GCISCO C9300L-STACK-KIT FIBER OPTIC CABLECISCOC9300L-STACK-KIT FIBER OPTIC CABLECisco Config 1 - power supply - hot-plug / redundant - 715 WattCISCOPWR-C1-...

Hi there, I am a new Cisco server user. I bought a used C240 MS to VMs just a couple of days ago. The server boots up, and everything seems okay until I shut it down. The server literally turned off, but the PSU fans still kept spinning at high speed...

Hi,I'm trying to setup Cisco Business 140AC Access Point but it's not working for some reason as I can't complete the initial configuration steps via ciscobusiness.cisco.To setup the Access Point I connect to it via Wi-Fi on my laptop and I'm able to...

I have a Cisco Small Business CBW240AC access point that will no longer power on and is older than 1 year old (so I can not get free Tech Support from Cisco).The device was purchased brand new from a Cisco Authorized Reseller.  When I contact the com...

I have a VPN L2TP Server and more than 10 users have been created when I connect more than one user to the VPN they get the same IP and drop the connection another would I have to fix this VPN inside cisco RV340 ? or make some configuration on the ma...

I have two Firepower 1120 connected in a HA Cluster, I can only access the management interface on the primary firewall via the data interfaces, therefore I cannot access the standby firewall management at all until it becomes primary?Is there someth...

What is the easiest/best way to copy the config from an FDM managed Firepower 1120 to another one exact same model?

Hi,I do not have any equipment to test with but I have been asked if this would be possible via a script:Screen 1: Always shows full screen self-view of the local person presenting or speaking with camara tracking (Both the PTZ 4K for Presenter and Q...