Hey everyone! I’m trying to connect to the Wi-Fi at Cromwell High School and could really use a hand. Does anyone happen to know the username and password for cps-wireless or the password for cps-guest? I would greatly appreciate it. Thanks a ton!
Forum Posts
Resolved! FPR-1010 firepower-failed
Hello, I have a firepower 1010 and I tried to upgrade it, later it began to reboot infinitely Reading the cisco documentation I applied upgrade revert after that, the console appears: firepower-failed # nor does it allow me to apply more commands onc...
This is a relatively new remote site and up 25 days. I was successfully able to install and configure Anyconnect VPN. It is currently running 7.2.8-25 out-of-the-box from Cisco. I have it staged for 7.4.2.2-28 Cisco's gold start. Show Disk: is sh...
Resolved! migration of firewall 5515X
we are migrating to a new cisco firewall (FTD) 2110 from cisco 5515X. What are the precautions need to be taken care, and how should I start the process when I get the New device?
Hi everyone,I have an issue with SASD. When I opened it on my laptop, the cameras were working fine. However, after installing SASD on my PC, the cameras are showing a black screen when I try to view them.!
My ASA running on 9.16.4 found the below vulnerabilities on my WAN IP, kindly check and help us to mitigate these Cisco Adaptive Security Appliance Remote Code Execution and Denial of Service Vulnerability (cisco-sa-20180129-asa1)CVE-2018-0101 TLS Pa...
I upgraded FTD version 7.2.8-52 to board 7.2.9-44 and got this error
I currently have an SNS-3715-K9 device with a primary power supply (SNS-PSU1-1050W). I am looking to order a secondary (redundant) power supply, but I noticed that in the CCW tool, the only available option listed is the SNS-PSU1-1200W-2. My question...
I need to pull all video for a specific date 24 hours, across 200+ cameras. Pulling clips in SASD is going to take forever. I can easily pull the native files using sftp /Media1, the files all have a .smd extension. Is there a program that will ope...
Hi GuysWhen backing up the FTD, it appears there are 2 ways of backing up the config, the full backup and the export of the config.What is the difference between the 2 please? and when would you use one or the other?Also, I assume in the event of a h...
Hi GuysI am configuring remote access VPN on my FTD, this is setup via cdFMC aka SSC managed in the cloud.Am I correct in saying to do this you go to Integrations > Other integrations > realmsCreate the Realm and LDAP servers, do you have to set the ...
Hi, I have an AXIS M3057-PLVE that all of a sudden started showing in VSOM as double panoramic view. When you go to the camera itself in the web interface it doesn't show that way and I don't see how to adjust the stream so it doesn't show that way i...
I have a Cisco CIVS-IPC-6630 camera that will not allow me to set up motion configuration. I get this error: "Error message:[Unable to listen to device for events. failed to turn on event history for motion events [failed to set new EventHRSetting's:...
Hi GuysI am looking to replace some ASA 5545-X firewalls, what is the best model to move to ?I am looking at - FPR-1150 or FPR-2120What is recommended?Cheers
I always understood that you never leave an interface exposed. If you want to modify an ACL on an interface you create a new one and then apply it to the interface before deleting the old ACL. This also protects you from disabling the interface in ca...
