01-12-2012 09:13 AM - edited 03-19-2019 04:14 AM
Hi all, was hoping someone could help.
I have a 2911 running CUCME 8.8 and an ISM module running CUE 8.6.1.
I can browse to 10.10.10.2 and access the CUE Admin webpage, however, when trying to run the initialization wizard and enter the details, I get the error message - "Login to CUCME as an administrator failed. Check your CUCME configuration".
I have configured the 2911 as follows (I've snipped out some of the config):
interface ISM0/0
ip unnumbered GigabitEthernet0/1
service-module ip address 10.10.10.2 255.255.255.0
!Application: CUE Running on ISM
service-module ip default-gateway 10.10.10.1
!
interface GigabitEthernet0/1
ip address 10.10.10.1 255.255.255.0
ip pim dense-mode
duplex auto
speed auto
!
!
ip http server
ip http authentication local
ip http secure-server
ip http path flash:/gui
!
ip route 10.10.10.2 255.255.255.255 ISM0/0
!
!
!
no dial-peer outbound status-check pots
sip-ua
mwi-server ipv4:10.10.10.2 expires 3600 port 5060 transport udp
!
!
telephony-service
no auto-reg-ephone
max-ephones 40
max-dn 40
ip source-address 10.10.10.1 port 2000
max-redirect 5
timeouts interdigit 5
system message xxx
cnf-file location flash:
load 7916-12 B016-1-0-4.SBN
load 7916-24 B016-1-0-4.SBN
load 7912 CP7912080004SCCP080108A.sbin
load 7945 SCCP45.9-2-1S.loads
load 7965 SCCP45.9-2-1S.loads
load 6945 SCCP6945.9-2-2-4.loads
date-format dd-mm-yy
voicemail 2999
max-conferences 8 gain -6
moh "flash:/music-on-hold.au"
multicast moh 239.1.1.10 port 16384
web admin system name sean password xxx
dn-webedit
time-webedit
transfer-system full-consult
secondary-dialtone 9
create cnf-files version-stamp 7960 Jan 12 2012 14:56:29
!
Can't see anywhere I've gone wrong. I have removed and re-added the web admin command with different credentials and nothing I try will make it log in.
Any help would be appreciated!
Sean
Solved! Go to Solution.