How do I configure the Cisco 4331 routers' ethernet-internal interface to communicate with a SM-X Layer 2/3 EtherSwitch Service Module?
Neither interface ethernet-internal 1/0/0 nor interface ethernet-internal 1/0/1 have the ip address command available. They don't have the "no switchport" command either.
I can do the "hw-module session 1/0" command to console into the etherswitch. Once consoled in I can configure the switch, it just won't communicate with the internal interfaces on the router.
Here are the references I've tried to use.
http://www.cisco.com/c/en/us/products/collateral/routers/4000-series-integrated-services-routers-isr/datasheet-c78-730357.html
http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/eesm/hardware/installation/guide/eesm_HIG.pdf
http://www.cisco.com/c/en/us/td/docs/routers/access/interfaces/eesm/software/configuration/guide/4451_config.pdf
I fee like we are missing something obvious!
