I'm really flummoxed. I pulled down the PPT stencils, as well as the other one that's monochrome, and installed them fine.
The problem occurs when I want to use one of the shapes that has two versions of itself in the same shape, e.g. "Route/Switch Processor with and without Si." It has two 'shapes' together built into one shape, and I only want one of the two.
How do I pull the shapes apart, and then save them as separate shapes?
Note there are several shapes that have been created this way... Frustrating!
Thanks in advance for any help. Don't know if this is the right forum, or if I have to go somewhere else.
jeremyNLSO
ArchiTech89
CCNA Routing & Switching, CCNA Security
MCITP, MCTS
Berlin, Germany
