Routers - Small Business

Hello, here is the topo : LAN0 <--ZywallUSG20<-- Internet Access --> ZywallUSG20 -->LAN1 with many computers-->RV110W-->LAN2       IPSECVPN <--                  --> IPSEC VPN it is a obligation and I have no choices except this topo. I use only fixed...

It was "clear" on my previous RVS4000 Cisco small Business Router the process for forwarding external Website to Internal server IP Address - 192.168.... My current Router RV042G has no clear section/process for this same task.  I need assistance in...

Hello - I've had a working gateway-gateway VPN (IPsec) working for several years.   The router is Netgear FVS318N Location 1:  Static IP / Netgear router (Business class internet) Modem is configured in bridge mode Location 2:  Dynamic IP (Residen...

Hello. in an attempt to stop the spread of Ransomware I am putting together a plan on how we can segregate the NAS in a second VLAN "VLAN3" I have created the VLAN and assigned the required port to it. I have also have 2 addresses inside that VLAN (V...

Hi I configured an ipsec vpn and i can connect with my client, on the Router RV130W i can see my client established connection, but theres no traffic and it is impossible to ping any device. Do i need to make a static route or a firewall roule? Than...

My WRVS4400N V2 router is updated (V2.0.2.2 firmware). But, when I access over Internet, using https (firewall -> https its enabled), some browsers cannot open because the SSL version is V3. How can I upgrade de SSL version of https?

I have installed a WRP500 on a static IP network with basic default configuration for the firewall.  I need to establish an endpoint URL for listening to an event notification feed.  How do I define that URL and allow the notificatin feed to get thro...

In IPv4 mode, you can set custom DNS servers with "Automatic Configuration" for DHCP.  In IPv6, you cannot do this. There is no option to set the DNS servers. Also if you try to set "Static DNS", under "IPv6 LAN Configuration", the changes are not r...

I am trying to set the custom DNS servers in IPv6 just like it is allowed in IPv4. This is not allowed in the "IPv6 WAN Configuration" when "Automatic Configuration" is selected. However, this is allowed in IPv4, you can select your own custom DNS s...

Hi, i have some problem on this device. hardware start and blink but not recognized by Router. I'm looking for dongle support list for this router, Where i could find it?

It was "clear" on my previous RVS4000 Cisco small Business Router the process for forwarding external Website to Internal server IP Address - 192.168.... My current Router RV042G has no clear section/process for this same task.  I need assistance in...

i have one rv 042 and i configured wan and lan interfaces.i already upgrade the firmware.its working good but i cannot open yahoo mail.please give a help.  

Firmwarev4.2.3.07 (Oct 8 2015 15:29:55 I have created a new service with TCP port 8007 to 80 in the service management under UPnp section. I already have three rules active there. But if I create the rule then with the IP address linked to it and en...