Routers - Small Business

Hello,I'm trying to make an attached topology.This router should be attached to 2 different ISPs on both WAN interfaces (ISP1 with IP address - A.B.C.D, and ISP2 with IP W.X.Y.Z) and I want to use DMZ, too. My idea is to make a L2/L3 segmentation wit...

I have a router rv110w, but i can not write "@" in the preshared key, and i have one @ in my Router 1800 series, and before i used a RVS4000 Router and in this Router i can put @ in the shared key.Thanks

Good morning!I am trying to set up a gateway to gateway VPN connection between a RV042G (central site) and a RV110W (newest firmware) which is used for presentation purposes on various customer's sites. The RV042G has a static IP. The RV110W has diff...

Hello Community,I have a strange problem with my RV110W router. I've set up a single port forwarding (80 and 8080) to my ethernet computer which I use for CRM application. It works for few days and then stops. I need to reboot the device and after th...

Dear people,Installed 1.0.2.6, did reset to factory defaults, then I setup wan, lan, vpn and qos. While setting up qos, I took into account the workaround described in the release notes of 1.0.2.6, issue CSCtr24497, meaning I used the ip-range and no...

This week, I replaced a netgear FVS318G with a Cisvo RV180, firmware 1.0.2.6.  I have a very limited knowlege of routers and protocols, mostly from exposure as a home user.  My goal is to define firewall rules on my RV180 that define when my tween-ag...

Hi,this is a bug report for RV082 hardware version 3 and 4, firmware version 1.x, 2.x and 4.x (all latest versions). I hope someone from cisco/belkin reads it.Summary:The snmp interface number of a VPN Tunnel change when the VPN tunnel disconnect and...

Customer has broken the aerial on their SR520 Router and was wanting to know if they can purchase an aerial on it's own? Can anyone suggest any options?

hi guys,I use a pretty simple configuration1 cisco SRP521W* WAN DHCP* LAN in a /28* wireless disabled* GRE tunnel enabling the access to a /11 network while sharing the local /28I configured a first router successfully : 10.xx.xx.0/28 , lan ip 10.xx....

Hello,I would like to priorize some protocols but i need some help. In fact want to priorize HTTP protocol over NNTP protocol but without limit NNTP bandwidth if HTTP is not used.If i play with high and low priority settings, NNTP speed is always red...

Hi,the small fan of a SRP541w seems to have 'melted'  it's way out of it's casing. Can anyone give me a parnumber for a replacement fan for this router?Michael