Routers - Small Business

So I have several RV260 that work perfectly with OpenVPN but id like to get client to site IPSec setup as an alternative. However nothing ive done seems to work with the Windows built in client. IKEv1 profiles result in logs stating that no IKE has b...

Just got a new RV260 Router.  Set it up using the wizard with a static ip WAN connection. Used the IP, subnet, gateway and DNS provided by the ISP.  The system status for the router shows as connected.   Able to access the internet and go one website...

I have just purchased a Cisco RV260 with the intent of beefing up security on our home network a bit, from the default router (now in bridge mode) provided by our ISP.I have run into the following issue with the firewall settings though. My rule set ...

Hi, First time using the RV260 series router. I'm setting up a client to site VPN connection using IPsec. It appears straight forward but I can't get it to connect. According to the Cisco docs it should be compatible with the native Android VPN clien...

Hi:I just upgraded my RV340 to 1.0.03.21 from 1.0.03.20.After the upgrade, my SSLVPN would not work.I am using CISCO anyconnect.  I get an error "no valid certificates available for authentication".I rebooted the router back to 1.0.03.20.  The VPN no...

I have a client-to-site VPN config on an RV340 that is working fine with Apple OSX and iPhone clients, using certs and xauth. I am now trying to connect a Linux client. I am receiving the error "INVALID_ID_INFORMATION" for no apparent reason.   Cisco...

I am requesting assistance with a simple static route.   I have 2 small LANs - 192.168.100.0/24 and 10.0.0.0/24. The RV340W is the main router connected to the internet. It is the gateway for the 192.168.100.0/24 network and has a 192 address on the ...

Hello,We are having Cisco RV345 Dual WAN Router having two WANs connected. One having 100 Mbps fiber connection and another having 10 Mbps leased circuit. Router is having firmware: 1.0.03.19 I want to control the Bandwidth of users in my Network by ...

Hello Please helpi'm trying to setup the RV340 for as an L2tp server.  i followed the directions in the attached pdf i found in another post and it works well, i can connect and stay connected for 2hr+(i haven't tested longer).  but as soon as a seco...

Hello I use RV-340 router with current firmware. Anyone had same problem like me with search results? Enabled web filtering and deny of porn content works good with search results and porn sites are blocked but when I change tab to video and graphics...

Hi, I have a site to site tunnel setup to a Strongswan system, the IKEv2 authentication occurs and the tunnels is established. The local group on the RV340 side is set to 0.0.0.0/0 yet after the tunnel is established no traffic appears to be send thr...

I've done quite a few site-to-site VPNs with Cisco Small Business Routers.  But I've never done one from scratch for Client-to-Site.  I'm converting the site from an old Netgear router with a Cisco RV340 Dual WAN VPN Router and have a few questions:I...

Got it figured out. I bolded the fix in the message.  I'm at a small business attempting to get a Cisco RV340 to work with Credit Card Readers and Printers through VPN. This information below describes the business setup, but not the problem I'm expe...

I've been making good progress deciphering the RV340 interface.  But there are a couple of things I'd like to understand:In VPN / Client-to_Site Tunnel Group / 3rd Party Client / Advanced there is an entry forRemote Endpoint with a  pulldown that inc...