Routers - Small Business

I previously posted about the inability to get a DHCP address from the LAN port of the SR 520.  I have set up another older laptop (I needed the serial port) and opened a session via the CLI.  The <show run> command yields a configuration file that l...

Hello,I am configuring a Cisco SR 520 for a small business network.  I successfully configured it and synched to the ADSL (AT&T) line.  I had the network up and was configuring NAT.  I was able to successfully connect to the Internet, and then I rest...

Im seeing a high amount of errors and discards resulting in latency issues up to 60ms on my ipsec0 interface.Im running the latest firmware.  Any ideas?  I have several RV082s and this is the only one with the issue.

Although I think this is an easy question, I am quite rusty when it comes to IOS.  In an effort to save money my Temple is not upgrading our still working Cisco 831.  We are running a primary network - the "office network" 10.100.10.0, and a new "Gue...

I see this is now available...  Can someone please indicate if V1.40 IPS is compatable with V1.3.0.5 firmware, or should I wait for a revised IPS?Also, anyone with any information regarding the installation/configuration/operation of this new firmwar...

3 offices, 2 have the 861 and one has the 881. All offices are able to map drives and connect to each other. I'm having a problem w/ a Riverbed appliance and have been troubleshooting w/ them and they claim the problem is in my network. When I try to...

We have recently installed several RVL200 routers and migrated them from ADSL (PPPoE) Internet access service to Cable modem. Now, we are facing the following problem:After a few hours of operation the router suddenly stops routing and it is not able...

Hello,I have a question regarding the RV042 and its IP-Sec capabilities.Does it support "Mode Config", an IP-Sec extension.If yes, is it documented somewhere?Regards,Daniel

We currently have three remote offices connected to the main office with gateway to gateway VPN's over DSL lines and everything is working fine. All offices have an RV042 with current firmware. We have added a second DSL line at every location and wa...

We have a WRV54G router and connecting from the outside to inside SBS 2003 server through VPN has never worked. I get a 720 error on the client and a error in the SBS server about no GRE protocol being passed through. I swapped out the router with a ...

I have an 831 with IOS 12.3(2) and what I'm wanting to do is to only allow certain websites.  I use SDM to configure and its telling me my IOS doesn't support the web filtering.If I update the IOS will it enable webfiltering on my 831?  Is there anot...

Anyone able to get Virtual passage to work on windows 7?  I have a RVL200 and it cant install VPN software.  I got off the phone with cisco and said they dont support it becuase its still in beta which it is not.  I has been released to MSDN subscrib...

I just bought the RVS4000.  It is slightly annoying that the admin site built into it can't fetch new firmware/ips direct from cisco, but nevertheless...I was looking for somewhere to register so I could get an email when new firmware/ips is posted. ...

Hi,yesterday, i'm experience problems with spam so i decided to upgrade de firmware on mi rvs 4000 from de version 1.1.12 to de newest version i foun, the 1.2.11. After the flash, i have no internet conecction, i tried to do anything but no succes. T...

HiI have a strange problem where i have 2 sites connected  using  a VPN on 2  CISCO877.  But WMI scripts are not running across the link. if i pull these out an replace them with a Draytek, the scripts run fine.Broad Lane LAN ----- Cisco 877 ========...