cisco rv042g setup problem

[raydan123]

i have a 2 internal computers

A: 192.168.1.10

B: 192.168.1.11

isp provide 2 ip, x.x.x.110-111

subnet: 224

gateway: x.x.x.97

router:

WAN 1: x.x.x.110

WAN 2: x.x.x.111

i try to setup following

computer A port 80, 21, 3389, 10000 map to WAN 1

computer B port 80, 3389, 8080 map to WAN 2

i bought a cisco rv042g, but it look like can't do what i want.

i try enable DMZ, then set DMZ host to computer A,

i try port range forward, but no way to set which WAN

i also try one to one NAT, but only have 2 public ip

i world like to know rv042g can do what? if not, i will buy another router

[jeffrrod]

Dear Customer,

Thank you for reaching the Small Business Support Community.

All I can think of is to set the "Bandwidth Management" settings to assign a better priority to a particular type of traffic to the desired WAN interface, besides that I see nothing else to try.  Please refer to the article below for details;

http://sbkb.cisco.com/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=589

I hope you find this information helpful and please do not hesitate to reach me back if there is any further assistance I may help you with.

Thank you for your time and patience,

Jeffrey Rodriguez S. .:|:.:|:.
Cisco Customer Support Engineer

*Please rate the Post so other will know when an answer has been found.

[raydan123]

i already sell the router, the router can't do what i want