04-06-2018 02:58 AM - edited 03-21-2019 11:07 AM
What could be the issue when a link connected to interface GigabitEthernet0/0/2.582 does not come up on the production router but works on a test router.
The config on the interface are okay.
ken-nai-edc-pe01#ping vrf voas001 10.234.253.129 rep 50
Type escape sequence to abort.
Sending 50, 100-byte ICMP Echos to 10.234.253.129, timeout is 2 seconds:
...................!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Success rate is 62 percent (31/50), round-trip min/avg/max = 1/1/2 ms
ken-nai-edc-pe01#clear arp-cache vrf voas001 10.234.253.129
ken-nai-edc-pe01#sh arp vrf voas001
Protocol Address Age (min) Hardware Addr Type Interface
Internet 10.234.253.128 - 7c0e.ce0d.f603 ARPA GigabitEthernet0/0/3.582
Internet 10.234.253.129 0 Incomplete ARPA
ken-nai-edc-pe01#
ken-nai-edc-pe01#ping vrf voas001 10.234.253.129
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.234.253.129, timeout is 2 seconds:
.....
The router is also connecting another link which is working fine.
Solved! Go to Solution.
04-06-2018 06:16 AM
Hello,
Please post your question in the main Routing section. MPLS is not supported on Small Business routers (RV series) so there is less chance for someone to answer you quickly here.
Thanks,
Kris
04-06-2018 06:16 AM
Hello,
Please post your question in the main Routing section. MPLS is not supported on Small Business routers (RV series) so there is less chance for someone to answer you quickly here.
Thanks,
Kris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: