RV340 - How to config QoS for VLAN Voice Traffic

[WITnet]

Need some help setting up QoS for voice VLAN.

I’m familiar with the RV320 but configuration has changed in the RV340.

Honestly, a better explanation of the QoS options in the manual would be very helpful.

 Setup

I have (2) VLANs, VLAN 1 for Data and VLAN 20 for Voice.

(PC’s & Printers on VLAN 1, IP Phones on VLAN 20)

Simply put, I’d like to give all VLAN 20 traffic priority over VLAN 1 traffic.

Just confused between options between Classes, Queuing, Policing and Bandwidth Management and in what combination. (Running Firmware: 1.0.01.18)

Our ISP connection is 100Mbps Down & 10Mbps Up.

Any clarification would be greatly appreciated.

[Thierry_TDG]

Running current fw 1.0.2.16

Same situation, same explanations needed :)

Moreover, what about applying QOS on IPSec S2S tunnels ?

Thanks.