cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
660
Views
0
Helpful
0
Replies

SR520-FE-K9, 124-24.T4, CCA 3.0, unable to enable NAT after disabling

bmbailey
Beginner
Beginner

When configuring a SR520 static IP address on WAN port, popup box directs user to delete and re-enable NAT. After disabling NAT no button exists to re-enable NAT. If CLI is used to fix issue, CCA states firewall is not supported. Issue started with CCA 3.0.

Factory reset needed to correct issue but then it starts all over again.

IOS version: sr520-advipservicesk9-mz.124-24.T4, CCA Version: 3.0, 3.0(1)

0 Replies 0
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers