SRP541W - IPSec VPN Policy

[Nicholas Root]

Recently we have purchased a few SRP541W for our small branch office VPN sites. While working with the config I have discovered that when trying to create a IPSec VPN policy, I am limited to only one "remote network" entry. This is typically not how VPN tunnels are bulit. We generally put the following remote networks in the tunnel.

10.0.0.0/8
128.0.0.0/8
172.16.0.0/12
192.168.0.0/1

How do I open a BUG ticket with Cisco and ask that they change the code?

[ccintolo]

You should be able to create multipe IPSec policies, one for each subnet. Near the bottom of the configuration page is a drop down box where you can choose the IKE policy to associate each IPSec policy to.

Best Regards,

Catherine Cintolo

SBSC Support Engineer