Should bandwidth match between every two router interfaces connected to each other? And BANDWIDTH is NOT the same as the "fastEthernet, GigabitEthernet, etc..." funtionality correct?
1.) Do you configure it from Global Configuration mode or per Interface? 2.) Do you have to have a loopback already created before configuring the router-id
I have an ASA 5515-X. My ISP provides me a /30 for the link and a /27 for my public IP space. How do I set up routing between the two? I have set the security level on both to 0. One interface called outside for the /30 link and one called DMZ fo...
Hi, I was able to get everything up and running and now I'm at one more crossroads due to printers. I have 2 networks behind a 2911, a network on 192.168.42 and there is a wireless network on 192.168.1. The weird thing is that 192.168.1 network can ...
We have a large number of branches with Cisco887VAG routers. They are set-up with 2 x IP SLA monitors, which are tracked such that if both IP SLA's fail then the router will switch from ADSL to it's 3G connection. IP SLA 1 points to a device on our...
Hi Experts I have a scenario in which I am kind of stuck and wondering if anyone can give me the best advice on how to accomplish itBasically I have following scenario and what I am trying to achieve is create a high availability in case one physical...
Hello All.I need solution on my exist setup. Currently we have single Datacenter, DR and Multiple branches. This is full mesh MPLS network. We are runningOSPF as Dynamic routing protocol, looking for migration into BGP. We have single service provide...
helloo, on a 3850, the management, interface, i can not add an ip address, is there a specific conf for this?here is what i have:int Gi0/0vrf forwarding Mgmt-vrfno ip addressNego auto I am trying to enter the comand:conf tint gi0/0ip address x.x.x.x...
I've been reading up on CEF which is a new topic for me.If I have a router with multiple equal cost paths learned via OSPF for example, how does the router distribute traffic between these paths? Is it dependent on CEF to be able to do this load bala...
Hi I am having a problem to figure out the reason of HSRP flapping on our Nexus 7000 pair running v6.2(10) . The problem comes time to time but after few seconds the flapping stops. below is the partial logs. Interestingly not all SVIs goes for HSRP ...
I have been tasked with creating a L3 design. It's not overcomplicated but I am not sure how to separate routing between WAN, VMs, and access. I have attached a quick drawing for illustration. I have thought about using BGP on the fiber ring and sepa...
hi everyone.we are doing static NAT of Agent station on Cisco ASA and running Avaya 1x Soft phone there.but we are unable to register the Avaya 1x application with Avaya gateway. Looks like NAT issue on Cisco ASA.without NAT phones gets registered. n...
Hi, I am facing problem to take backup of router running configuration through TFTP server.TFTP server is running on Window 8 platform.During copy runningconfig to flash display the error message "TFTP: error code 2 received - 16739%Error opening ...
Dear All, I have the below tunnel configuration over a physical links of BW 155Mbps, however and while trying to utilize the full BW of the link we could not exceed 55Mpbs by any mean!! HYG the configuration sample along with the topology.@r1:=====in...
