Routing

We have a 7206VXR with an NPE-G1 processor. We're running the standard stuff on it, but here are the highlights:eigrpipsec tunnels (approx 45)netflowqosextended ACLsbgp (1 neighbor)We just enabled netflow on it to send the data to an external source ...

Hello,we have some strange problem on our c7200 IOS 12.2(31) with an eBGP peer. the eBGP session begins as usuall and without any problem, all prefixes (Full BGP table) are announced to the neighbour, of course during this time the CPU goes high up t...

Hello community,since a some period of time my edge router (cisco7200 with NPE-2G) has a massive performance problem causing by BGP process.rc-e100-49-69#sh processes cpu sorted | i BGP 204  1224991632 222733885       5499 14.07% 10.89% 10.71%   0 BG...

Hi, I'm trying to manipulate traffic for my WAN. Basically, I'm trying to stop traffic for a particular /24 block from coming in via Link 1 and instead come in via Link 2 and 3.after adding "ip prefix-list asprepend seq 25 permit 1.1.169.0/24" into o...

I have a 3825 with fan 3 failing according to syslog messages.ENVMON-4-FAN_LOW_RPM: Fan 3 service recommended I have taken the router a part and see that fan 3 is slimmer than fans 1 and 2. I am trying to find a replacement fan, but only can find fan...

Setup:Site A Cisco 2911 -- 2 T1 WIC.  One going to Site B 1841 another going to Site C 1841.I am looking for a way to setup a Polycom QOS, judging by several forum posts about this, would it be better to create an access list with the Polycom IPs to ...

I am trying to troubleshoot a QOS problem on a Sprint MPLS connection.  I currently have two 50Mb ethernet circuits from the CE router to Sprint's PE router at two locations.  I get choppy video calls between these locations and the only way I can re...

Hi,I have two offices in rural area with a quite distance between them. Offices are connected with private wireless 100Mbps and cooper 100Mbps links provided by different ISP. Wireless connections are delivered as a private L3 Ethernet link but coope...

I've been trying to crack this one for a while but I can't see the wood for the trees. This router feeds a Sonicwall security device at 192.168.0.180 on the inside and performs ADSL2+ on the outside. I can do domain lookups on the internal lan (the o...

Hi, may someone kindly guide me.I’m a new CCNA and not have much working experience.Lately some of the users migrate from a subnet to a new subnet. After migration, they cannot SSH into their servers. I did a sh ip route from both subnets gateways to...

All the branch end MPLS routers injects sites BGP prefix in to the service provider’s cloud by forming EBGP neighbhorship with PE.In my scenario, I need to inject same prefix from two of the branches so that the actual MPLS route is always better tha...