Routing

What is the proper syntax / commands for displaying the ARP table on N5K?Attempted various SH IP ARP parameters, but never finding anything in the ARP table except the Default Gateway's HSRP and associated physical IP Addresses.I do have numerous hos...

Hoping I can get some help here. I am have an 851w router being used as a firewall for a small office. I used the CCP/SDM to set up a basic firewall and everything seems to be running smoothly. There is only one problem, the internal Windows Domain c...

Hi Folkswhile y r conneced over remote desktop session to server , can u install software or some patch  on this server,however i tryed to install patch for the acs 4.2, but i failed ,is it becoz of that?thanks

Hi     I try to work the netfow on my router 881 with ios 15.0.1 but when t put rhis command          BOA_SDSL#sh ip flow top-talkers          % Cache is empty     Here the output of commandBOA_SDSL#sh ip flow interfaceFastEthernet4  ip route-cache f...

Not sure on the best way to do this. Here is my setup:Cisco 1841 Software (C1841-ADVIPSERVICESK9-M), Version 15.1(2)T1, RELEASE SOFTWARE (fc1)Cisco Internal IP:192.168.X.254Cisco External IP 64.X.X.5 (NAT)Netopia DSL Router:Internal IP: 192.168.X.253...

I am troubleshooting an issue on a T1 where data latency spikes, but total bandwidth does not. I am interested in learning how proportional bandwidth sharing applies to the default class. The below document states, "If not all of the bandwidth is all...

Hi,We have area 10 and area 20 conected to core 0. Both area standard area. ( IA and external routes are available ). A new link of high bandwidth is deployed between two locations of these areas. And we need to push the traffic between area 10 and a...

Hi, i will going to buy a router 2911 but i want know if support a interface ADSL modulo like backup in case that my primary link WAN Ethernet down and up the adsl link with a module HWIC ADSL pots. Thanks

Hi All,I have two C1941.The first C1941 does not support SNTP but the second C1941 supports SNTP.The only difference which I can spot is their license. The first C1941 does not have security license but the second C1941 has.Does anyone has any clue?W...

Hi everyone,I'm about to install a new E1 onto my 3845 as backup line for my data network.We usually use VWIC2 cards since our infrastructure covers EU and US sites. But this time, I ran out of stock and so did my supplier.I have a VWIC-1MFT-G703 car...

I'm trying to set up my Cisco 1841 with a with SDSL service.  I have the WIC-1SHDSL-V3 card installed in the router and have followed the configuration example at: http://www.cisco.com/en/US/docs/ios/bbdsl/configuration/guide/bba_atm_shdsl_ps6441_TSD...

Purchased a 2911 router for a customer, and I'm sure I'm missing a module here.Teleco installed T1 and left connection to smart jack.  Router only has 2-3 copper ports.Can I get away with configuring the blackbox with RJ45 to the copper port on the r...