Routing

Topology Above is the simple topology based on which I have the scenario which I would like to resolve: Notes:1. BGP running between routers2. Networks behind each ISP can transit into each other using DC1 and DC2.3. Site 1 - has TPG IPVPN connection...

Dear all,   I have a problem regarding netflow export from a Cisco 4331. I want to export netflow traffic to a specific destination. The problem is that the source should be the loopback interface on the router which is in a specific VRF:   Example: ...

I have set up my DHCP Pool to bind by Interfaces' as the Client ID for example:Pool Marquees : Utilization mark (high/low) : 100 / 0 Subnet size (first/next) : 0 / 0 Total addresses : 254 Leased addresses : 0...

I am having trouble configuring the interfaces on a NIM-2GE-CU-SFP when using network boot (TFTP) to load the router configuration.  The Cisco 4331 ISR router chassis interfaces accept their configuration via network boot (e.g., Gig 0/0/0), but the i...

Our 911 center purchased a RV320 to be used solely for 4G internet access via ethernet connection.  On the compatibility list includes Verizon's new USB730L.  Trying to set it up and it doesn't seem to recognize the device.  Contacted Verizon and the...

HI community, im having issues to understand why this QoS is behaving like this.router is 4331/k9 my understanding is since the main Policy(parent) is CBWFQ it assigned up 50% and 40% to the class in the main. then the remaining BW is assigned to the...

Hi,I Have a Cisco Router and a 6506 Switche which are interconnected through GRE and EIGRP, using only 2M CAT6 cable, but when i do IPERF bandwidth test between two computers one is connected to 6509 and one is connected to my router, the bandwidth t...

Trying to route between two networks using ONE Cisco 1951 router. 192.168.0.x on G 0/0, and 192.168.1.x on G 0/1.config tint g 0/0ip address 192.168.0.1 255.255.255.0ip route 192.168.1.0 255.255.255.0 g 0/1no shutdownexitconfig tint g 0/1ip address 1...

Hello,Please help me understand how to mirror this config from IOS to - IOS XE Cisco IOS XE Software, Version 03.18.02.SP.156-2.SP2-extinterface GigabitEthernet0/1mtu 1998no ip addressload-interval 30tx-ring-limit 5media-type rj45speed 1000duplex ful...

Good day all, May someone please assist with IPSec Tunnels and Routing. Here's the scenario: We have 2 RV110W routers on separate networks. They have separate modems providing internet access so essentially in separate locations. We have created an I...

i have bought a new 2960x-48tsl. an it worked correctly. i wanted to upgrde the ios. but it faild. After i repluged the power cord, it remained on this statement: Testing Memory from 0x00000000 to 0x1fffffff...\ s. Notice the s character after the st...

Hi, My concern is regarding BGP load-sharing using loop-back and maximum path. In single homed (two link between two routers in different AS)  environment if I am doing load-sharing using loopback or maximum path, What exact difference is in between ...