Routing

I would appreciate your support on the following LABI have one Router VXR1 connected to 2 routers: ISP1/ISP2.R1 is always using ISP2, even though ISP1 is reachable. ping from R1 to 8.8.8.8 using source interface F0/0 isn't reachable when the track is...

Sorry to take up some of your precious time but I have a small question. We have a 1gbps dedicated internet (Fiber) AT&T link and I'm trying to determine if the total load (inbound + outbound) is a little high for the link. Since this is full duplex ...

Hi GuysAn external company has put some Mikrotik cloud services routers on our site, they do not have a public IP on the WAN interface but can still build a VPN to other Mikrotik routers, is this because they register to the cloud to a registry like ...

Hello FAM!!, Hope you are doing well. I have topology as attached, Site A is my primary site, site B my backup [DR]. We have clients connected via site A, via ipsec tunnels to the outside interface IP say [101.101.101.10]. Under the encryption domai...

Hello everyone!I am trying to give out ip to serial port with /8 mask and i have an error i attached a picture please help me i need to do this for tomorrow. Thanks.

Hi,Is it possible to configure NAT on multiple routers? I need to perform outside NAT, and NAT sessions should be in sync between routers somehow in case packet enters via one, and exits via other router.Are there any other options?

Hi,I have a Cisco ASR1001X device running iOS 16.09.04. The log keeps showing the following error.From what I've read about similar problems, it happens with BDI interfaces, but in my case, I only have the x.x.x.x range configured on the physical int...

IntroductionIn this blog we will try to explain how we can  prevent an IOS router from advertising a specific sub-network in a large advertise network BGP. We cannot filter the route if we're advertising the routes using a Null Route. When you inject...

Hi, I'm wondering whether it's possible to read MROUTE MIB OIDs for the mroute table that belongs to a VRF (instead of the global RT). Currently, I can only see the OID for the global routing table. I've looked in to the option to use SNMP Contexts, ...

Having some issues and super frustrated. Been searching the web for last four hours trying to figure out why.Set up a router with two networks. Added NAT everything works as expected. All traffic is NAT’dNet A ------ Gi0-Router-Gi1------- Net B, Inte...

Hi,I have a requirement to take a service from a supplier who is directly connected to a Cisco ASR 9001 and is providing services via tagged vlans. I need to terminate this service on a Cisco ASR 1001-x in the network. I thought the best way would be...