256
Views
0
Helpful
1
Replies
RIP Over Firewall
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-15-2024 11:53 PM
I need one basic info on RIP settings between two devices over firewall. I believe I just need to allow UDP 520 to the destination address 224.0.0.9 nothing else right. Am I right?
Labels:
- Labels:
-
Routing Protocols
1 Reply 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-15-2024 11:59 PM
Hello
Yes udp 520 however why would anyone use rip nowadays, im not so sure its supported with some vendors?
Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.
Kind Regards
Paul
