I am using an MX router from a closed location to test "SIGraki" configuration with our Umbrella account. I am following the procedures in this document https://documentation.meraki.com/MX/Site-to-site_VPN/MX_and_Umbrella_SIG_IPSec_Tunnel. I have con...
Forum Posts
Resolved! Load balance will be done in sdwan
I have two transport wan connection in Cisco viptela sdwan and will load balance will be done by default ?
Resolved! SDWAN 20.12.4 license issue
Hi All,Iam trying to build a sdwn lab with version 20.12.4 and it saying license unassigned for 2 router. anyone can clarify what type of license it is asking and were can i get this license for lab purpose.Mode over Control connections are not comin...
Hello Cisco Community,I am encountering an issue when adding a device template to vManage. Although all the settings and configurations in the template are correct, I receive the following error:Failed to update configuration - /ncs: devices/device {...
Resolved! Edge router TLOC selection preference
I'm looking for a solution to be able to shift traffic across multiple wan links on individual edges on an over arching HUB Spoke topology.Example HUB A has a singular transport however Spoke B and C have multiple transports such as LEO, cellular/LTE...
Nice to greet you team, I have a question, I have a branch with two BFD tunnels, a link was down and the branch appeared on the dashboard in “Site BFD Connectivity” as “Partial”, however more than 30 days passed and the alarm disappeared from the das...
Hello Expert,I hope you're doing well. I am currently exploring the IaaS feature of Cisco SD-WAN and have reviewed the design documentation. However, I still have some questions regarding the prerequisites for the control complex.Specifically, I’m un...
I recently rebooted my vManage. Post reboot of vManage I received some alarms in the vManage console indicating for some of the cEdges "bgp-peer-state-change idle" message was seen. But when checked the BGP status in each cEdge there was no state cha...
I have integrated Cisco SDWAN with umbrella, when i run show sdwan umbrella device-registration. i can see following #show sdwan umbrella device-registrationNAME STATUS TAG DEVICE ID DESCRIPTION--------------------------------------------------------...
I am looking for some Cisco documentation to clarify a behavior I am noticing on the cEdge router. When I perform a clear sdwan control-connections command on the router, the RIB is rebuilt. This router is also running other routing protocols in the ...
Hello everyone! On several Cisco C9410R and C9500-48Y4C switches, on 12/17/2024, logs about the expiration of certificates with cn=sdn-network-infra-ca in 7 days were triggered. Please clarify whether there will be a negative impact on the operation ...
Somebody know why vManage can't show traffic on sub-interfaces? It shows only traffic on physical and tunnel interfaces
Resolved! Hub-and-Spoke Topology Question
Hi All I'm working on a SD-WAN Hub-and-Spoke Topology, but i want to avoid traffic flow between spoke to spoke, for example : the DC site using VPN 100, and the branch A using VPN 10, branch B using VPN 20, in this circumstances i need to route-le...
Hi!I have implemented the service chaining functionality in my SD-WAN fabric (20.12.4), defined in the service VPN section of a Configuration Group, with the tracking option enabled to test when the firewall becomes unavailable.Everything works corre...
Hello all,I had challenge to find from which template is attached BGP configuration. However after 2h checking find that someone attached: "neighbor 172.16.x.x soft-reconfiguration inbound" from CLI template. Actually full BGP config was attached fr...
