Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
474
Views
0
Helpful
6
Replies

Tloc Extension using NAT

Go to solution
K.Inaba-MD
Level 1
Level 1

‎09-08-2024 11:49 PM

Hi Everyone,

By inserting NAT settings on the WAN interface of cedge, we are checking the operation of TlocExtension.

The cedge establishes a control connection, but does not establish a BFD session.

I would like to establish a BFD session, is it possible to share any similar knowledge?

The SD-WAN versions are as follows:
　vmanage,vbond,vsmart: 20.15.1
　cedge(C1111-8P): 17.12.03a.0.4

Regards,
Kei

0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
K.Inaba-MD
Level 1
Level 1
In response to Dan Frey

‎09-13-2024 08:09 PM

We used a private color because the network environment uses a closed network, but if you use NAT, you need to use a public color regardless of the type of network.

View solution in original post