"For Tacacs+ Authentication We will be using "Default Device Admin" Access Service".
Go to Access Policies-->Access Services-->Default Network Access-->Identity. Let Single result selection is selected.
3.Configure Policy Element: - Go to Policy Elements --> Authorization and Permissions --> Device Administration-->Shell Profiles. For Admin and regular users (created in step 2), now we need to assign different privilege level. So privilege 15 will be given to “admin” user and privilege 1 will be given to “regular” user.
Under Shell Profiles, click on “Priv 15”, and select the default and Maximum privilege static value as 15 for admin privilege under common task tab.
Under Command Sets area, for Admin user account we have to configure “Allow All”. Once we check the box “permit any command that is not in the table below” without adding anything in the command box, the admin user is allowed to execute any command i.e. Priv lvl 1 to lvl 15.
Similarly we need to add a command set for “regular user” account which allows only show commands privilege level. The Regualer user will not be able to run any other command except “Show command”.
Shell profile for non-admin/regular user with Default Privilege level set as 1 under Common Task tab.
4.Configure Access Policies: - Now we need to create a Service Selection rule under Access Policies-->Access Services and Match protocol as tacacs and the access service is selected as “Default Network Access”.
Rule 1 for admin user. Set the condition based on group membership. If the user is a member of admin group then we have to map the specific shell profile and command set.
The next Rule i.e. Rule-2 is for regular users (non admin users). For regular user we need to allow only “show command” (Privilege 1) with enable password to run the show commands.
Hi all,i'm struggling with an authentication related problem. I have an IP Phone (Polycom VX201) that connects to a contact center to download its configuration. Inside this config, there is the 802.1X supplicant credentials (username and password). ...
i would like to install certificate chain (root and sub certificate) ,private key and certificate for router in under one trustpoint to use VPN. So i conbined private key and certificate as a one pfx file .
i install certificate chain ( root and sub)...
Hello, I have a ISE DACL Over ASA VPN deployment. There are many DACLs that are assigned to users with a certain AD group membership when they hit our ASA via SSL VPN. How can I see a dACL on ASA CLI if a user is not connected? In the "show acce...
I have a request come in from one of our customers, they are looking to see VPN user Activity, how long have they been logged in would be enough.
I have looked at the FMC Reporting and cant really see anything for this.
The FMC does not in...
Hi, We have a two node ISE deployment and the primary has admin and policy and the secondary has monitoring and policy services. recently after we have upgraded to ISE 3.1 from 3.0 we are experiencing random application server restart on the primary ...