Showing results for 
Search instead for 
Did you mean: 
Community Member

While use "enable sslvpn" ,

Warning: unexpected configuration tag 'secondary-username-prompt-text' (line=646,column=11,position=19416)

Warning: unexpected configuration tag 'secondary-password-prompt-text' (line=648,column=11,position=19603)

Warning: unexpected configuration tag 'secondary-passcode-prompt-text' (line=650,column=11,position=19779)

Warning: unexpected configuration tag 'form-order' (line=688,column=7,position=21793)

why ??

ASA# show version

Cisco Adaptive Security Appliance Software Version 8.0(5)
Device Manager Version 6.3(4)

Compiled on Mon 02-Nov-09 21:22 by builders
System image file is "disk0:/asa805-k8.bin"
Config file at boot was "startup-config"

ASA up 11 days 15 hours

Hardware: ASA5520, 2048 MB RAM, CPU Pentium 4 Celeron 2000 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash Firmware Hub @ 0xffe00000, 1024KB

Encryption hardware device : Cisco ASA-55x0 on-board accelerator
(revision 0x0)
Boot microcode : CN1000-MC-BOOT-2.00
SSL/IKE microcode: CNLite-MC-SSLm-PLUS-2.03
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.05
0: Ext: GigabitEthernet0/0 : address is c47d.4f98.be02, irq 9
1: Ext: GigabitEthernet0/1 : address is c47d.4f98.be03, irq 9
2: Ext: GigabitEthernet0/2 : address is c47d.4f98.be04, irq 9
3: Ext: GigabitEthernet0/3 : address is c47d.4f98.be05, irq 9
4: Ext: Management0/0 : address is c47d.4f98.be01, irq 11
5: Int: Not used : irq 11
6: Int: Not used : irq 5

Licensed features for this platform:
Maximum Physical Interfaces : Unlimited
Maximum VLANs : 150
Inside Hosts : Unlimited
Failover : Active/Active
VPN-DES : Enabled
VPN-3DES-AES : Disabled
Security Contexts : 2
GTP/GPRS : Disabled
VPN Peers : 750
WebVPN Peers : 25
AnyConnect for Mobile : Disabled
AnyConnect for Linksys phone : Disabled
Advanced Endpoint Assessment : Disabled
UC Proxy Sessions : 2

This platform has an ASA 5520 VPN Plus license.

Serial Number: JMX1416L4TE
Running Activation Key: 0x4701c052 0xc892eb53 0x18b239ec 0xb9647c84
Configuration register is 0x1
Configuration last modified by enable_15 at 10:16:05.467 UTC Tue Nov 16 2010

Hi - did you figure out what caused the Warning messages?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Quick Links