Server Networking

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Cisco UCS X-Series Energy Efficiency Offer

 

Forum Posts

I am attempting to downgrade from 5.1.3.N1.1 to 5.0.3.N2.2b for standards compliance.When following the ISSU steps for validation of the install all command I receive the following error on the following command:sh install all impact kickstart bootfl...

Hello,We are installing a N1K 4.2(1)SV1(5.1)   and for this purpose installed VSM on a Seperate DataCenter  Vsphere 5 Cluster onto a blank ESX host. Our problem is that VSM and VEM cannot see each other. What step may we missing?Thanks in Advance,Bes...

canero by Level 1
  • 9506 Views
  • 6 replies
  • 0 Helpful votes

Hello everybody,Just a quick question, how do you restore a running-config (or a Nexus .bin file) to a Nexus 7010. Is it thesame process as the IOS base scenario. Please explain and help. Thank you in advance.--chie                  

How do you handle overlapping vlans when using OTV between Data Centers.  i.e. in Data Center 1 i have vlan 100 with ip address 10.10.100.0/24 and in Data Center 2 I have vlan 100 with ip address 10.20.100.0/24.  I don't want to combine these into on...

Hi All I have two  nexus 5548UP switches and we are trying use this as data centre switch as well as the core switch.so we have to run HSRP on these two to get redundancy.I have attached sample diagram of what we are trying to do.I have read several ...

Hi,I would like to have some suggestions and recommendations for a single homed design for a nexus 5k, 2k, 1kV.Firstly the design that we are hoping to do is as follows:                    5k=5k                    //     \\                    2k     ...

rramlal by Level 1
  • 1113 Views
  • 1 replies
  • 0 Helpful votes

Hi,I would to check confirmation regarding the max fex (NX2K 2224T) are supported on NX5K (5596UP) on both full L2 or L2/L3 design.In my case i will implement 2x5596UP as Core datacenter with 14 FEX (NX2K 2224T series) for Server access.Please i need...

I'm getting ready to upgrade our 2 nexus 5010's which are running vpc to 2 HP C7000's which have flex 10's in them.  The flex 10's are dual homed to each nexus via a 10 gig link.  Now because the Flex 10's will only do fast lacp I cannot use the ISSU...

Hi , I am not sure if I am missing something here , but could anyone tell me why a few VLANs have port associated with it while a few dont . For eg. VLAN 100 says active but does not have any members , if I do a "swithport mode access 100" on a parti...