Hi ,
I am not sure if I am missing something here , but could anyone tell me why a few VLANs have port associated with it while a few dont .
For eg. VLAN 100 says active but does not have any members , if I do a "swithport mode access 100" on a particular port it shows up but this hasnt been done for other ports but they still show up under "Ports"
Also the VLANs in whihc there are no ports it gives the following error :
100 enet Vlan Mode: vmode: 134562224 n/
Error:vlan_mode is not defined!
VLAN Name Status Ports
---- -------------------------------- --------- -------------------------------
1 default active Po1, Po10, Po13, Po14, Eth1/5
Eth1/9, Eth1/10, Eth1/11
Eth1/12, Eth1/13, Eth1/14
Eth1/15, Eth1/16, Eth1/17
Eth1/18, Eth1/19, Eth1/20
100 VLAN0100 active
101 FCoE_Fabric_A active Po11, Po12
200 VLAN0200 active
242 MGMT-VLAN active Po1, Po10, Po11, Po12, Po13
Po14
300 VM-Traffic-VLAN active Po1, Po10, Po13, Po14
400 NFS-VLAN active Po1, Po10, Po11, Po12, Po13
Po14
500 vMotion-VLAN active Po1, Po10, Po13, Po14
600 Packet-Control-VLAN active Po1, Po10, Po13, Po14
700 iSCSI-A-VLAN active
800 iSCSI-B-VLAN active
900 VLAN0900 active
VLAN Type Vlan-mode
---- ----- ----------
1 enet CE
100 enet Vlan Mode: vmode: 134562224 n/
Error:vlan_mode is not defined!
101 enet CE
200 enet Vlan Mode: vmode: 134562224 n/
Error:vlan_mode is not defined!
