Here is a interesting question that came in and i thought I could document it for the wider audiance.
Subject: SPA9000 issue
Please can you help on the below issue?
I have the spa9000+spa400 & spa942X3 + spa962X1
I am using the spa 400 with two analogue lines.
How can I configure the phones so that the analogue lines ring on a different led on the phone? Ex. analogue number X1 ring on led 1 and analogue number X2 ring on led 2.
Thanks & Regards,
check out the attached screen shots.
I have the SPA400 port ID setup with a name that I like , or i could have used the port ID that are there.
Then I allowed my contact list on my SPA9000 to looking at this incoming Port ID and direct the call to an appropriate hunt group.
So calls coming in from SPA400 line 1 or Port ID 1 which i have called 'PSTN' are directed to hunt group 200
So calls coming in from SPA400 line 2 or Port ID 2 which i have called 'Gate' are directed to hunt group 201
I think you could easily adapt this for your requirements. See attached screen shots on how i did it. but this information is in the Administrators guide anyway.
Great write-up. Thanks for taking the time to share this Dave.
Is it possible to do this with calls coming in from an ITSP SIP trunk that supports multiple inbound calls to the same number? That is, can you take the first call and have it illuminate LED1, then have the next call illuminate LED 2, etc? My client would like this as it makes it easier for them to hold and transfer multiple calls (example: to transfer a call they press the hold button and tell their colleague to pick up on line 1, or if they are on a call and a new one comes in they press the hold button and then press the button next to the incoming call).
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: