cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5831
Views
0
Helpful
0
Comments
Patrick Born
Cisco Employee
Cisco Employee

If you choose to deploy a SPA400 in an Asterisk environment, you will need to define which SPA400 line to use.

This document describes how to accomplish this.

exten => 6XXXXXXXX,1,Dial(SIP/L2{EXTEN},20) 

By setting Ln string before an extension in the INVITE, where "n" is the line  number on the SPA400, one can choose which line to route the call to (in the  previous example it goes to Line 2). If not using Ln, the call will end up on  first available line (the SPA400 is then treated like a trunk). This has been  tested to work with 1.1.2.2 SPA400 firwmare.

<end>

Special thanks to Ognjen Seslija for sharing this information with the community

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: