02-17-2020 12:44 AM
Hi All,
Is it possible to configure a L2 hand-off on a border node that is already configured with both IP-Transit and SD-Access Transit?
Also, are there any restrictions using L2 hand-off on a Cat9600?
Many thanks in advance.
02-25-2020 12:45 AM
I dont see a problem with this , as long as this is a dedicated interface which will be needed to be setup as a trunk for L2 handoff
Im not aware of any HW limitiations at this point.
07-10-2020 10:15 AM
Hi,
No Restriction, but the recommendation is to use a separate device for L2 Border handoff to safeguard the entire Network meltdown due to Spanning tree issues.. Hope this helps..
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: