Switches - Small Business

Hello Community, We have SG500X 48 ports POE switch. We have Avaya IP phones connected in the switch and ports are configured as trunk. We have voice VLAN 100 and data VLAN 20. Default VLAN 1 still running on the switch.VLAN 1 cannot be deleted. Swit...

The switch will provide a dhcp address to an end computer.  The switch is connected to the internet.  I can ping from the switch to either network, but I cannot ping through the switch.  What am I missing?  Thanks.

Helloi am a little bit rusty/newbie in Cisco Networking. Maybe some of u guys could help me out? i got some problem to setup our new network enviroment with a SG550XG 24F (Layer 3 ) and several 2960X (Layer 2) Switch.We have several VLANs but somehow...

Hello, I have a question regarding stacking ports in this switch Can I configure all the ports in this switch as stacking ports? specifically, can I use SFP+ or RJ45 ports for stack, or there's a dedicated port? Regards jorge

Dear All, I have a PoE switch model "SG300-28PP 28-Port Gogabit PoE+ Managed". I want to use this switch with ePMP AP and also ubnt Nanostation radio. Initially  I have tried but nothing to do. Below the configuration information. Please help me if ...

I recently bought a cisco sg300 28-port switch. i have two networks, that are 10.198.32.0 /24 and 169.250.177.0 /24. i wanted route between two networks so that users in 10.198.32.0 /24 network can access the printer 169.250.177.108/24 in network 169...

I am getting this alert every second. It is slowing my server down to  a crawl. Alert%HAL_config_poe-A-POEFailDetected: POE ERROR(i2c_read_mem failed addr 0x1214 dev_num 0 val 0x0) was detected: POE is Disabled untill Reset   Any help is appreciate...

Does anyone know how the SG200 series reacts to gratuitous ARP packets? We use APs that use them and want to know if the switches will block the APs in any way, or otherwise hold onto the ARP packets instead of just discarding them. Thanks. Stuart

After connecting SG200-50 switches and SG200-26 together in LAG, the following problem occurs: if you disconnect the two network cables of a switch, Clients on the other switch disconnect for 5-6 pings. It's normal? Thank you all

Hello community, I've problems to boot the switch with the running config. System Operational Mode:  L3 Mode     System Description:             SG300-20 20-Port Gigabit Managed Switch     Firmware Version (Active Image):     1.4.7.6Boot Version:    ...

Hello, As the MFEFX1 is End Of Sales ( http://www.cisco.com/c/en/us/products/collateral/switches/small-business-stackable-managed-switches/eos-eol-notice-c51-736791.html ) , and proposed replacement is the MGBLX1 Can someone confirm ( from field e...

We are considering purchasing and stacking two SG500X switches, but whether it makes sense depends entirely on the failover time. Judging from the manual, if the backup fails, the failover time is practically immediate, but if the master fails, the b...

my Cisco Small Business 300 Series Managed Switch is having problem its power light is static and not blinking after i have reset it, it started blinking but after vlan configuration and creation of trunk i plugged into the trunk and back it...