Switches - Small Business

Any plan to add RIPng support in future firmware versions to the SG500X?  SG500X already supports RIP for IPv4 but not IPv6.  This would really round out the IPv6 support on these switches.

We are attempting to connect to trunk a 302-8PP switch to a 2960x and having difficulties in getting access to the web UI from outside of the local 302 switch ports. The 302 passes traffic on vlan 24 but we cannot Ping or access the Web UI of the 302...

Hello, I need to configure dot1x for an IP-phone (Avaya 9620) and a windows client. The IP Phone and PC must work on same port, the PC is connected via the IP Phone.Both, the phone and the PC need to pass authentication by mac address. Authentication...

Hello experts,  is it possible to stack two SG500-52 switches using CAT6 cable on port G49 and/ or G50 Thanks in advance 

Ok.  This one has me very stumped. I have an SG300-10 acting as a layer 3 router in my lab environment. I have an SG300-52 acting as a layer 2 switch. I have a Fortigate firewall set up to route traffic to the internet or through an IP SEC tunnel to ...

I have Cisco Small Business (SF302-08PP) , I need   connecting  iphone set ( type Mitel ) and PC to the same interface on the switch and each  of them assign to the separate Vlanbest regards,Osama

Hi all, First post here, so excuse me if I post in the wrong section. Last night at work we performed some switch swaps in two of our buildings. Prior to the service windows, each building had an Avaya switch (4548 in one building, and a 5698 in the...

Hiis there a CLI command to display the SFP model/type inserted in ports ?on ios switches, there are several commands to show this informationi have some SFPH10GB-CU3M and SFP-10G-SR and want to see from remote in what slot they are inserted.regards

Hi, I'm setting up a new server (Dell PE R730 with vmWare Esxi6) for Etherchannel on 2 of it's ports yet it's failing in a wierd way. I've done this before without any problems but when I plug both connections in it pings back fine locally, yet fails...

Hi, I have some questions regarding the configuration of these two devices. The specifics; SG300-52P - version 1.4.7.6 RV320 - version v1.3.2.02 (2016-09-23, 15:17:06) The RV320 is configured as a gateway, ipv4 only, connected to a cable modem. Th...

I need help enabling ssh for my device. I go to Security - Access Method - Access Profiles and click add. Then I add in SSH and give it a level like 14 and close. I try to SSH to the device but it does not allow me to connect from the LAN. I go back ...

I am trying to setup a SG220-28 to support a 2504 Wireless Access Controller and what will end up being 4 Aironet 1702i WAPs. At another location, I have observed a SG300 switch with access points (different than those above) attached to a trunk port...

We Installed Two SG500 Switches in Native stacking mode We are facing problem with TCAM In SG500 Maximum TCAM Utilization is 2000 (2K) IPv4 Routing Resources i changed the Maximum Entries up to 1925 But in our case                                   ...

Hello, I have a SG500X. I have activated the DHCP server, but I need to add the option 66 dhcp.I must add a text type: "http://192.168.150.150:5000/provisioning/0xxxxxxxxx/$MA.xml" but the cisco will not let me. it seems that only accepts hexadecimal...