Switches - Small Business

My company has been having a few issues recently where SG300-28A switches 'go dead' to field locations. When they arrive back to us we take a look at them and are prompted for the MAC address, serial number, and hardware version. After a lot of fight...

I have a question, if I configure a SPAN session on a pair of Nexus 5500's in which the source is a server plugged into a FEX, and the destination is a server plugged into each of the 5K's via a 10gig breakout port (the default ports on these 5K's be...

I have setup a link aggregation between 2 Cisco SG300 network switch. I had assign port 1 and port 2 (both are Gigabit port) as a member of LAG1. From the Cisco switch GUI,it is shown that the both port is an active member. In this case, will the LAG...

Hello,I have a Synology NAS that is connected to several IP Cameras through a SG300 switch.From time to time the IP cameras become "disconnected" at randomWhen I reboot the switch, the access to cameras is re-established.Problems: it requires an exte...

I've been quite familiar with configuring a number of the Cisco SG models, including the SG300-20, etc.  I just purchased an SG350XG-24T 10GbE switch, and was running through the usual configuration for VLANs and the associated settings.  Typically o...

Dear Sirs. My brand new SF500-48P switch seems to have problems while operating with PoE enabled. When I try to enable power on port #1, for example, the power is enabled on port #2, and so on. I tried resetting the device to factory defaults, as wel...

Hello,   I'am running an ESXi Server in VLAN 20 for all servers. Switches are managed in VLAN 1. There is Layer 3 between them, so that they could connect. Problem is, that FindIT only discovery devices, which are hosted in VLAN 1. Is it possible to...

I have a new Cisco SG200-26P set up with two LACP LAGs for the two servers I have running on the same VLAN, both bonded with IEEE 802.3ad Dynamic Link Aggregation and have a speed issue with the second LAG. Port GE8 is enabled with auto negotiatio...

Installed one of these at a client, and cannot access the PoE management on the Web interface. Thought perhaps it was the browser preventing, but the same issue occurs in Chrome, Edge, IE and Firefox.  Switch currently running 1.0.0.17 firmware, but ...

Hi, I am planing to buy srw2024-k9-eu (SG300-28) model i want ask if product is Fan-less one before i upgrade my passive hp switch.

Hi All, I have a location with two Cisco SG300 switches (28 port and 52 port), which both connect to my ASA 5505, which then connects to the ISP. I have a guest and staff subnet and since my ASA only has a base license, I can't do trunk ports, so ...

I have a new Cisco SG250-26HP 26 port Gigabit PoE Smart Switch and 3 new Cisco WAP571-A-K9 V01 the switch supports 802.3at PoE+, 802.3af, however I have never managed to get it to connect at anything other than 802.3af. I have loaded the latest firmw...

Hai , Cisco Catalyst 2960 series switch showing " Press Return to get started " when connect using Teraterm . using this message not possible to enter in switch settings .How to solve this issue or skip from this message . Error message has been upl...