Switches - Small Business

What is the MIBs_Sx500_v1.4.0.88 download for?  I'm currently bringing all of my switches to 1.4.0.88 Firmware version.  Is this something I need to update to for my SG500-52 or SG500-52P switches or is it for something else.  I believe they call it ...

Hello,we have a serious problem over here with some new SG 200-08P switches firmware: 1.0.6.2They are setup behind 2 SG-200 50 layer 2 switches - actual firmware 1.3.2.02.We have 4 VLANs: 1 for DATA and 2 for PHONE, 10 fpr MGMNT and 20 for GUESTS - o...

I feel that it's a security risk to have a port set up as anything other than Access if it's only going to have "dumb" hosts plugged into it (i.e., printers, workstations, etc.).  So, I usually only assign the management VLAN as the PVID of a trunk p...

I am setting up QoS (advanced mode) on Cisco SG-300 52 switch.I decided to go with DSCP to manage packets priority. While setting it up I found a configuration page (see the attached file for screenshot) where it is possible to map DSCP values to a p...

I have two switches, as follows:Switch #1 is an SG300-20, L3 mode, *.254.VLAN3 is 192.168.3.254.VLAN10 is 192.168.10.x.VLAN20 is 192.168.20.x.Port 1 is an Access port on VLAN3.Ports 2-10 are Access ports on VLAN10.Ports 11-19 are Access ports on VLAN...

This is a brand new switch, set to L3 mode, and I am connected to port 5. By default, all ports have VLAN1 (management) set as their PVID and are set to trunk mode. I can connect without issue, and nothing else is connected to the switch.I have perfo...

If I don't have any VOIP devices, should I just leave all the QoS settings to default? We have an AirPlay speaker on our network, so could there be benefits in raising the QoS priority so that the audio streams smoothly to this device?Cheers,Max

I hardly understand any of the features on by SG200-18 switch. Where I to even begin to learn what this stuff means? I wonder if I should change any QoS settings but I have no idea what most of this stuff means (the administration guide assumes you'v...

Hi,We have a SF300-24P with the version 1.3.7.18 and LLDP MED isn't working with IP Phone Yealink T28.The phone advertises via LLDP in the TLV Type(127), TIA-TR41 Media Capabilities with Network Policy Capable showing that it is able to receive the v...